Wuxi Ruijia Accurate Machinery Co., LTD

High quality product, professional service, being the core supplier in laser industry!

Home > News > Content
Hot Rolling Mill Improve The Processing Performance Of The Alloy
- Oct 24, 2017 -

The Hot Rolling Mill is the equipment to realize the metal rolling process. There are two kinds of cold rolling and hot rolling, and the cold rolling is relative to hot rolling. The process of hot rolling mainly refers to the process of rolling over recrystallization temperature. The advantages and disadvantages of hot Hot Rolling Mill are at the same time, the advantages and disadvantages of hot Hot Rolling Mills are mainly described below.

I. Advantages of hot Hot Rolling Mill

1. Hot rolling can significantly reduce energy consumption and reduce costs. In hot rolling, the metal plasticity is high and the deformation resistance is low, which greatly reduces the hot rolled section of metal deformation.

Energy consumption.

2. Hot rolling can improve the processing performance of metal and alloy, will be casting the coarse grain broken, significant crack healing, reduce or eliminate the casting defects, the transformation of the casting structure into deformation tissue, improve the processing performance of the alloy.

3. Hot rolling is usually used in large ingot, large-scale rolling, not only improve the production efficiency, but also to improve the rolling speed and realize the continuous rolling process and automation to create conditions.

When the hot Hot Rolling Mill is running, the starting speed must be controlled, because it has an important effect on the efficiency of the whole mill. Do not want to see is the hot rolling machine in the accurate operation of the start speed is slower, not only affect the work efficiency, but also lead to the billet or rolling and roll between the force can not achieve a good state.

And hot Hot Rolling Mill start-up speed is slow, indicating that it has obvious deficiencies in performance, if the machine when the speed of the boot is not effectively improved, then the billet or rolled pieces of production efficiency will be less and lower. If unable to start quickly overload, it will produce a larger billet rolling speed too slow.

In order to reduce the appearance of similar phenomenon, hot rolling machine before running, should first of its motor power, rolling speed, product specifications, Hole-type technology, such as inspection, to ensure that the volume will not be reproduced in excess of the capacity of the equipment, otherwise it will cause the device start-up speed is slow.

Second, also to the hot Hot Rolling Mill bearings to check, to see if the lubrication is good, if not enough lubrication, hot-rolled machine aerodynamic speed will also become slow, triggering a series of adverse consequences. If these two aspects have no problem, the hot rolling machine basically can start normally.

In addition to the slow start of the hot-rolling machine, the output of the finished product can sometimes be biased, resulting in a lot of reasons, even if the same set of hot Hot Rolling Mill product size will be uneven. But it also shows that either the roll gap is unreasonable or the hole-type process is incorrect.

In order to reduce the deviation of the product size of hot Hot Rolling Mill, it is necessary to strictly obey the rolling process of the product, especially to the standard of on-line adjustment of bar material, and within the internal control standard of negative deviation rolling.